Sewage Sludge Mixer NONFOOD

For efficient mixing of polymer solution into sewage sludge




INDAG sewage sludge mixer type DLM/KA is used for effective mixing of polymer solution into sewage sludge.
INDAG DLM/KA permits an efficient sewage sludge dewatering process with filter press and belt filter press by creating a big and stable flock. Especially in cases where dewatering process is not a dynamic process but rather a static process. Mixing volume of long DLM/KA mixer casing is of adequate size to allow introduction of sufficient mixing energy.


Advantages of DLM/KA

  • No pressure loss
  • No blockage
  • Entwining (clog) free
  • Homogeneous mixing result
  • Mixing energy can be changed variable and adapted to product or capacity changes
  • Higher DS-values of dewatered sewage sludge
  • Lower polymer consumption

Technology of DLM/KA

INDAG mixer type DLM/KA has shark fin form mixing elements on rotor and no mixing elements in stator (mixer casing). This geometry allows effective introduction of mixing energy and prevents blockages. Rotor of mixer is supported by drive shaft of motor. INDAG DLM/KA is equipped with a double acting mechanical seal. Mixer is available in two pressure ratings. Execution 6bar for pressure loss belt filter press and 16bar for filter press.

horizontal or vertical position of mixer is possible

Pressure levels
6 bar, 16 bar

1.4301 (AISI 304), 1.4404 (AISI 316L)

Double acting mechanical seal

Flange DIN 2633, ANSI ‚ #300

Rotational speed
1450 rpm

20 m3/h to 250 m3/h

Mixer sizes and capacities of DLM/KA

Subject to technical modifications.
max. capacitym3/h 2060120250
sludge connectionmm 65100150250
polymer connectionmm 25254050
power (16 bar)kW 1,535,57,5
power (6 bar)kW 1,11,52,24,0

Dimension drawing of DLM/KA (6 bar)

Scroll to top